Abrasive spiral bands, conical

Spiral Band, 1-1/2" x 7/8 x 2-3/8, Tapered Shape, 80 Grit, Aluminum oxide

Technical data

Technical information

Spiral Band, 1-1/2" x 7/8 x 2-3/8, Tapered Shape, 80 Grit, Aluminum oxide

Description

For universal applications from coarse to fine grinding.

In ISO 2421, abrasive spiral bands are designated as "cylindrical sleeves".

Advantages

Abrasive spiral bands fit securely on the rubber drum holder as the holder expands during use.
Outstanding service life even under the toughest work conditions, due to special manufacturing.
Highest possible cost-effectiveness due to particularly high stock removal rate and aggressiveness of the abrasive.

Recommendations for use

To easily change the abrasive spiral bands, give them a slight clockwise twist and pull them up and off. When doing so, leave the rubber drum holder clamped in the power tool.
To ensure the abrasive spiral band is securely attached, follow the minimum speed for the rubber drum holder.
Use the appropriate grinding oil for the material to significantly increase the service life and the abrasive performance of the discs.

Ordering notes

Safety notes

The maximum permitted peripheral speed is 6,000 SFPM.
For safety reasons, the maximum permitted rotational speed indicated must never be exceeded.
Do not allow abrasive spiral bands to protrude beyond the rubber drum holder.

Workpiece materials: Aluminum; Annealed cast iron; Brass; Bronze; Cast steel; Cobalt-based alloys; Copper; Fibre-reinforced thermosetting plastics (GRP, CRP); Grey/nodular cast iron (GG/GJL, GGG/GJS); Hardened, heat-treated steels over 370 HV (38 HRC); Stainless steel (INOX); Steel materials with a hardness > 54 HRC; Steels up to 370 HV (< 38 HRC); Thermoplastics

Applications: Deburring; Leveling; Roughening; Sharpening; Step-by-step fine grinding; Surface work; Working on edges; Work on weld seams